Installing a new Repeater
Installing a node
Look here to update a note.
Take the node from the box and charge it fully over USB-C.
Flashing and configuring
- Connect with USB-C to your computer and open MC flasher in Chrome.
- Repeaters can't be configured in the app, but need their online config tool.
Note to self: we need to have an offline option as well.
When setting up take note to
- Jot down the public key on your laptop so you can later add the repeater to your companion contact list.
- Set preset to EU/UK Narrow.
- Set the location of the node on the map.
Other settings
- set tx 2
- set agc.reset.interval 4
- set multi.acks 1
- set rxdelay 3
- Auto Advert Interval (Flood): Set to 12 hours or more (up to 48 hours).
- Auto Advert Interval (Zero Hop): Set to 0 (disabled).
Public/Private key issues
- Public Key: Check if your auto-generated Public Key prefix (the first two characters) are unique.
- Go to the MeshExplore Stats [1].
- Is there already a repeater using your prefix? If no, you're good to go.
- Is your prefix in use? Scroll down to the MeshExplore Unused Repeater Prefixes.
- Select one you would like to use and the Meshcore Custom Key Generator site will open. You will see the prefix you selected. Click Generate Key.
Copy the public and private keys and save them. We'll finish setting up the repeater and change them at the end using the web console.
- Name: It is helpful if your repeater gives a hint about the location, such as a landmark, neighborhood or cross streets.
- Location: Set the Latitude and Longitude in decimal format (47.xxxx, -122.xxxx).
- Guest and Admin Password: Use a strong password. Repeaters can be administered over the mesh from the Meshcore app.
Radio Settings
- Repeaters and clients use the “USA/Canada (Recommended)” preset.
- Frequency: 910.525 MHz
- Bandwidth: 62.5 kHz
- Spreading Factor: 7
- Coding Rate: 5
Setting Private and Public Keys
If your auto-generated key did not have a unique prefix, you should have generated a new private and public key and saved them. Go back to the Web Flasher [2] and above the list of all the devices, on the right side, click on the Console button and connect to your device. Once you are connected you will see a command prompt:
- At the prompt, type in
set prv.keyand paste in your Private Key. - Type in
reboot. - After your device reboots, verify that the private key is correct by running
get prv.key.
Path hash mode
get path.hash.modeto check current setting (should be 0).- Change it with
set path.hash.mode 1for 2-byte,set path.hash.mode 2for 3-byte.
Region Settings
Should we add `nl-ams` to all repeaters?
Last checks
- Test if you can add the node to your companion user list before you put it in a high and hard-to-reach position.
- Make sure that the solar panel is facing south.
Current issues
- Douwe has to learn how to do OTA updates.
Setup hardware
The setup process is nicely detailed in a booklet in the box.
---
Antenna Docs
Summary
Antennas and their qualities.
Antennas
There are several antennas.
Henk ordered these: